FIMAR GL33 Benutz Und Wartungsanleitung Seite 28

LAVA STONE GRILLS
To "transform" and adapt the appliance to the gas mains in use, close the gas supply faucet
and perform the listed operations.
– Burner nozzle replacement.
– Heat power adjustment to minimum
burner nozzle replacement
1. Remove bottom of the appliance.
2. Unscrew the nozzle and replace it with the one suited for the gas used.
Heat power adjustment to minimum
METHANE GAS powered appliance
1. Turn on the appliance and run it at maxi-
mum power for about 10 minutes.
2. Rotate the burner control knob to the min-
imum power position and pull it out.
3. Turn the minimum adjustment screw (D)
EN
clockwise or counter-clockwise to achieve
a stable flame.
4. Assemble the burner control knob and ro-
tate it to turn it off.
LIQUID PROPANE GAS powered appliance
(LPG)
1. Remove the knob.
2. Fully tighten the minimum adjustment screw (D).
For liquid gas (LPG) type (G30/G31), the screw (D) has a 1,10 mm diameter calibrated
hole.
3. Pull out the knob and tighten the second burner screw (if installed).
4. Turn on the appliance and make sure the flame is stable.
5. Turn off the appliance. Seal the adjustment screw with paint and repeat the operation on
the other burner (if installed).
6. Reassemble the burner knob and the other burner knob (if installed).
GL33 - GL66
D
- 12 - English language