AEG TP4080TWC Benutzerhandbuch Seite 19

1)
Problem
Incorrect program selection.
The filter is clogged.
was set to
trocken) .
The load was too large.
Unsatisfactory
drying result.
The airflow slots are clogged.
Dirt on the humidity sensor in the
drum.
Dryness level not set to desired
level.
The condenser is clogged.
The filter is not locked into posi-
The loading
tion.
door does not
Laundry is trapped between the
close
door and the seal.
Not possible to After cycle start it is not possible to
change the pro- change the program or option.
gram or option.
Not possible to The option you tried to select is
select an option. not available for the selected pro-
Acoustic signal gram.
is emitted.
Unexpected du- The drying duration is calculated
ration time on according to load size and damp-
the display. ness.
The water container is full.
Program inac-
tive.
Possible cause
Dryness (Trockengrad) option
iron dry (Bügel-
4)
Remedy
Select a suitable program.
3)
Clean the filter.
Change Dryness (Trocken-
grad) option to higher level.
Do not exceed the maximum load
size.
Clean the airflow slots at the bot-
tom of the appliance.
Clean the front surface of the
drum.
Adjust the dryness level.
Clean the condenser.
Put the filter in the correct posi-
tion.
Remove trapped items and close
the door.
Turn the tumble dryer off and on.
Change the program or option as
required.
Turn the tumble dryer off and on.
Change the program or option as
required.
This is automated — the appliance
is working correctly.
Drain the water container, push
the Start/Pause button.
ENGLISH 19
2)
5)
3)
3)