Operation / Settings; Operation And Maintenance - GRAPHITE 59G323 Betriebsanleitung

Deinstallation of the dust bag is similar to installation, only the sequence of actions is reversed.
It is recommended to empty the bag after it is half filled.
SWITCHING ON / SWITCHING OFF
The mains voltage must match the voltage on the label of the sander.
Switching on – press the switch button (1) and hold in this position.
Switching off – release pressure on the switch (1).
Locking the switch (continuous operation)
Switching on:
● Press the switch button (
● Press the switch lock button (
● Release pressure on the switch (
Switching off:
● Press and release the switch (
OSCILLATION SPEED CONTROL
Speed of sander oscillation is controlled by turning and setting the control wheel (7) (fig. F) in desired
position. It allows to adjust the power tool working speed to match characteristics of processed material.
● Increase the oscillation speed by turning the wheel (
● Reduce the oscillation speed by turning the wheel (
Choose proper oscillation speed when the sander operates with switch lock button pressed.
Oscillation speed with load may be lower than the speed set with no load.
FINISHING SANDER OPERATION
● Whole sanding area must rest on the processed surface.
● Turn the sander on, apply moderate pressure and move it on the processed material.
● When finishing polishing, reduce pressure and lift the sander above the processed surface and only then
you can switch off the tool.
Disconnect the tool from power supply network before starting any regulation, maintenance or
repair.
● Always keep the sander clean.
● Remember to always keep the ventilation holes of the tool casing pervious.
● Never use any caustic agents for cleaning plastic elements.
● In case of excessive commutator sparking check technical condition of carbon brushes of the motor.
REPLACEMENT OF CARBON BRUSHES
Replace immediately worn out (shorter than 5 mm), burnt or cracked motor carbon brushes. Always
replace both brushes at a time.

OPERATION / SETTINGS

1) and hold in this position.
2) (fig. E).
1).
1).

OPERATION AND MAINTENANCE

12
7) counter-clockwise.
7) clockwise.