Using The Anti-Theft System; Browsing Through The Menus - Parrot RKi8400 Bedienungsanleitung

wire to the 12V ignition and the black wire to the
ground. If correct the Parrot RKi8400 will display
'Goodbye' when the vehicles ignition is switched off.
- If it is the case, you can skip to step 7.
- If it is not the case, You may need to switch the
location of the yellow and red wires. This can be done
simply by reversing both terminal spade tags
located on the Parrot wiring.
Do not connect the yellow wire to the permanent
12V, otherwise you will cause the vehicle battery to
discharge.
7. Mount the microphone between the driver side visor and
the rear view mirror. The microphone must be aimed
at the driver.
8. Slide the car stereo into the Parrot RKi8400 cage and
attach the faceplate.

Using the anti-theft system

► Refer to the installation diagram on page 7.
To avoid any risk of theft, do not forget to remove the face-
plate of your Parrot RKi8400 when you leave your vehicle.
Without this front, the Parrot RKi8400 cannot be used.
- To remove the faceplate, press the eject button in the
top left.
- To replace the faceplate, put it on the right side of
12
the car stereo. Once the faceplate and the car stereo
magnets get in touch, press the left side.
Always make sure the Parrot RKi8400 is switched off
before removing the faceplate.

Browsing through the menus

• Press the jog wheel to access the main menu.
• Browse through the menus by turning the jog wheel and
confirm by pressing the jog wheel.
• Press the button to go back to previous menu. Press
the red button to get to the main menu.
• While playing a song, press the
menus. While navigating through the menus, press the
Play button to get to the Now Playing screen.
Selecting the language
1. Press the jog wheel and select
2. Select your language and press the jog wheel to confirm.
button to get to the
Settings > Language.