Technical Specifications; Electrical Connections - Dea 212E Bedienungsanleitung Und Hinweise

Programmierbare steuereinheit

Inhaltsverzeichnis

Verfügbare Sprachen

3 TECHNICAL SPECIFICATIONS

Power voltage (V)

Flashing output 230V

Auxiliary power output (24Vaux)

Safety power output (24Vsic)

Max motor power

Fuse F1

Fuse F2

Operating temperature limit

Radio receiver frequency

Max. no. radio controls managed

Complete the electrical connections following the indications in "Table 1" and the diagram on page 49-50.

WARNING Connect to the 230V ~ 50 Hz mains using an omnipolar switch or other device that ensure omnipolar mains cut-off, with a

3,5 mm contact opening distance.

WARNING For adequate electrical safety, keep low safety voltage wires (controls, electro-locks, antenna, auxiliary power) clearly separate

from 230V ~ power wires (minimum 4 mm in air or 1 mm via supplementary insulation) placing them in plastic raceways and securing

them with adequate clamps near terminal boards.

WARNING All wires must be striped and unsheathed in the immediate vicinity of terminals. Keep wires slightly longer to subsequently

eliminate any excess.

1-2

Power input 230 V ~ - 50Hz (L = phase, N = neutral)

3-4

Flashing output 230 V ~ 50 Hz max 40W

5-6-7

Motor output 2 max 500W (5 = open, 6 = shared, 7 = closed)

8-9-10

Motor output 1 max 500W (8 = open, 9 = shared, 10 = closed)

Output 24 V ~ controlled safety device power. To be used for TX photocell and safety device power when checking their

11-13

operations at the beginning of every manoeuvre.

Output 24 V ~ auxiliary and uncontrolled safety device power. To be used for auxiliary device, RX photocell (in any case) and

12-13

safety device power when checking their operations at the beginning of every manoeuvre.

WARNING operations with 1 motor: N.C. input closing limit switch.