Connect Power Cord; Establish Network Connection; Configure Processor With Controlspace Designer Software - Bose ControlSpace EX-1280C Installations- Und Bedienungsanleitung

pro.Bose.com

8. Connect Power Cord

The EX-1280C conferencing professor uses a removable IEC power cord, and can operate with AC mains line
voltages from 85 to 264 V AC at 50/60 Hz, 60 W max.
To power on the EX-1280C, connect the power cord to the rear panel. Once powered, boot times may be as long
as 40 seconds. A menu appears on the LCD display and the Power LED will change from red to white when the
processor is ready for connection/operation.
Note: Make all audio and network connections before connecting the power cord.

9. Establish Network Connection

Connect the EX-1280C either directly to a PC, or through an Ethernet switch. The EX-1280C should be connected
to the switch or PC using the ControlSpace port. Ensure that the PC is on the same subnet as the EX-1280C using
one of the following three methods:
• Set PC to DHCP and connect a DHCP server to the network. Both the EX-1280C and the PC will obtain an IP
address from the DHCP server.
• Set PC to DHCP and without a DHCP server. Both the EX-1280C and the PC will obtain an AutoIP-assigned IP
address.
• Set PC to a static IP address and use the front panel to assign the EX-1280C a static address on the same
subnet.
For more information, see the ControlSpace Designer Software Guide from pro.Bose.com or inside the software
help system.

10. Configure Processor with ControlSpace Designer Software

If all the network connections and settings are done correctly, ControlSpace Designer should automatically
identify the EX-1280C on the network.
With a network connection in place and ControlSpace Designer software installed, use the Hardware Manager
tool inside ControlSpace Designer software to scan and update the processor firmware. Once the processor
status reads "Up-to-Date" in the firmware panel, proceed with your system design using ControlSpace Designer
software.
For full details on using ControlSpace Designer software to configure, control, and monitor the processor or
entire systems built with Bose networked system electronics, consult the help system inside the software, or visit
pro.Bose.com and download the ControlSpace Software guide.
Installation and Operation
Installation and Operation Guide - 21