Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6. Rinse kettle interior thoroughly, then drain the rinse water. Do not leave water sitting in unit when not in
use.
7. Using mild soapy water and a damp sponge, wash the exterior of the kettle, rinse, and dry.
NOTE: For more difficult cleaning applications one of the following can be used: alcohol, baking soda,
vinegar, or a solution of ammonia in water.
Avoid the use of chloride cleansers, which may damage the kettle's stainless steel surface.
WARNING: Steel wool should never be used for cleaning the cooking chamber of the kettle.
Particles of steel wool become embedded in the cooking surface and rust, which may corrode the
stainless steel.
NOTE: Unit should not be cleaned with a water jet.
8. Leave the cover off when the kettle is not in use.
SCRAPER BLADES
1.
Remove retaining ring and slide scraper blades off agitator arm.
2.
Place parts in a pan of warm water to soak.
3.
Clean in a sink, using a warm water and mild detergent solution.
4.
Rinse with fresh water.
5.
Allow to dry thoroughly on a flat, clean surface.
PRODUCT VALVE
Daily - clean product valve as follows:
1.
Open product valve.
2.
Disconnect air hoses.
3.
Remove air cylinder.
4.
Remove valve tee.
5.
Remove all O-rings.
6.
Clean air cylinder, do not submerge in water. Wipe clean and sanitize.
7.
Clean and sanitize tee and O-rings.
8.
Grease and reinstall O-rings.
9.
Reinstall valve tee to kettle outlet.
10.
Reinstall air cylinder to bottom of tee.
11.
Reconnect air hoses.
12.
Close valve and check for alignment.
Steel Pads
Werbung
Inhaltsverzeichnis
