EN
7.1.
"Economic temper."– to set economic temperature
which automatically changes set temperature when the
fans operate at the lowest speed.
* - default settings
III. Dimensions
IV. Mounting
Surface mounting, opening is prepared in the wall for the connection cable d13 and two holes for installation of
the box bottom.
43
d13
43
Attach the box bottom cover to the wall leaving approx. 3 cm of cable from the surface. Put the battery to the
socket at the board, polarity "+" outwards, connect the plug to the board and close the box cover (see the draw-
ing) by attaching the left side (1–2) and then gently press the right side (3). Connect the other cable plug to the
socket of the recuperator (RS485_1).
16
d4
30
30
86
Mounting drawing
2
2
1
1
Assembly drawing
www.salda.lt
3
3