Salda FLEX Bedienungsanleitung Seite 13

EN
3.
"View Alarms"
In case of any fault the unit is stopped and alarm is displayed on the
screen:
"System reset?" –is used for deleting of system faults
3.1.
Sensor faults are shown when out of a min and max range
"TJ sensor" – supply air temperature sensor (-40 °C to +120 °C)
"TL sensor" – ambient air temperature sensor (-40 °C to +120 °C)
"TA sensor" – extracted air temperature sensor (-40 °C to +120 °C)
"TE sensor" – exhaust air temperature sensor (-40 °C to +120 °C)
"TV sensor" – return water temperature sensor (-40 °C to +120 °C)
"GP sensor" – pressure converter fault (only when the converter is
using current control signal)
"CO2 sensor" – CO2 converter fault (only when the converter is us-
ing current control signal)
3.2.
Other faults
"Fire input" – external fire signal input is active
"Antifrost"- critical minimum water heater temperature
"Overheat" – overheat of the electric heater (see.: electrical connec-
tion diagram)
"Rotor fail" – overheat of the supply or extraction fan motor (see.:
electrical connection diagram)
"Change filters" – contaminated filters ( see: II.6.11.) or external
signal
"Low pressure" – working at pressure support mode before reach-
ing the set pressure
– working at pressure support mode before reaching the set
pressure
„False Psi" – it is impossible to support set parameters in pressure
mode.
4.
"Languages"
The following languages can be selected:
Lietuvių,
Русский,
English,
Français,
www.salda.lt
View Alarms
Exit
System Reset ?
→
Sensor fault TJ
Motor overheat
View Alarms
Exit
System Reset ?
Sensor fault TJ
→
Motor overheat
System V2.2
Date - Time
View Alarms
Languages
Sensors values
Extra
System V2.2
Exit
English
Lietuvių
Русский
Deutcsh
5/7
3/5
13