Salda FLEX Bedienungsanleitung Seite 11

EN
2.
"Fan speeed" – allows selecting the speed
"Building protection" operation with minimal speed and economic
temperature. (see. II.7.1), "minimal", "nominal" or "Stop", "low",
"middle", "high" (see.: Service manual 17.1.)
The speed of the supply and extraction motors of the units with EC
motors can be adjusted individually setting their speed and pressure
(see II.6.7 and II.6.8)
3.
"Set temperature"
The desired supply or extracted air temperature can be set from 15
to 30 °C.
4.
"Menu" – other settings (see II.)
"Schedules"
"Date-Time"
"View Alarms"
"Languages"
"Sensors values"
"Extra"
"Menu configuration"
5.
Indication based on the setting of the maintained supply or
extracted air temperature: (see II.6.3.1) "Supply air temp." or
"Extract air temp."
6.
Extra:
"NC" or "Communication error" - no connection with the unit's
control board.
"Deicing" - activated unfreezing function for the plate heat ex-
changer.
"Change filters" – contaminated filters (see. II.6.11).
"Economic" – from external Stop signal the unit works at the lowest
speed and under the economic temperature.
"Stop input" - the unit is stopped from the external input signal.
"Standby (Sleep)" - when the fast button "Run/Standby" function is
selected (see II.6.5.3.)
"Boost/fireplace" - when the fast button „Boost/fireplace" function is
selected ( see II.6.5.3.) or external signal.
– if the selected function is on (see II.6.5.1.)
"Night cooling" – if the selected function is on (see II.6.5.1)
"High CO2 level" – allowed CO2 level is exceeded (see II.6.5.2)
"Battery low" – Battery should be replaced with the new one.
"Critical supply temp." – when supply air temperature drops below
16,5 °C
„False Psi" – it is impossible to support set parameters in pressure
mode.
7.
Current time and date is displayed (see II.2)
www.salda.lt
Manual
Fan speed middle
Set temperature low
Supply air temp. Stop
Deicing
7:28 2013-06-04
Fan speed low
Set temperature
20 °C
Menu 19 °C
Supply air temp. 18 °C
Deicing
7:28 2013-06-04
Fan speed low
Set temperature 19 °C
Menu
Supply air temp.
Deicing
7:28 2013-06-04
Fan speed
Set temperature 19 °C
Menu
Supply air temp. 18.7 °C
communication
eror
7:28 2013-06-04
System NC
Date – Time
View Alarms
Languages
Sensors
values
Extra
SUN
SUN
SUN
low
SUN
6/7
11