Bellelli Augusto Bedienungsanleitung Seite 12

rests completely on the seat and against the backrest.
Warning: The areas where the seat belts need to be
inserted are marked in red. Do not insert the car's seat
belts in positions other than the indicated ones.
Pass the car's seat belt between the base and the seat
(fig. 18).
Fasten the car's seat belt.
Place the lap section of the car's seat on the area (I) at
EN
the base of the frame (fig. 19).
Insert the diagonal section of the car's seat belt in the
belt lock (J) located on the same side of the buckle of the
car's seat belt (fig. 20).
How to remove the child seat from the car
Release the car's seat belt.
Pull out the seat belt from the child seat and allow it to
retract.
How to use the child seat (fig. 21 – 26)
How to position the child (fig. 21 – 26)
Press the adjuster (C) and simultaneously pull both the
harness straps of the child seat (fig. 21).
Press the red buckle button (M) to open it (fig. 22).
Move away the buckles and place them on the sides of
the child seat (fig. 23).
Place the child in the child seat.
Bring the two hooks of the belt together.
Insert the joined hooks in the buckle (M) (fig. 24). A click
indicates that the buckle has been fastened properly.
Position the padding sections (L) on the shoulders and
chest of the child and pull them completely (fig. 25).
Pull the front adjuster strap (D) to fit the safety harness
close against the child's body (fig. 26).
Warning: During the journey periodically check that the
child has not freed himself from the child seat.
How to release the child from the seat (fig. 21 – 22)
Press the adjuster (C) located underneath the seat and
simultaneously pull both the harness straps of the child
seat (fig. 21).
Press the red buckle button (M) to open it (fig. 22).
Take out the harness straps and take them off the child.
Maintenance and disposal
Remove the covers completely to wash them.
How to remove the cover:
Press the red buckle button (M) to open it.
Tilt the child seat completely backwards.
Press the adjuster (C) and simultaneously pull both
safety harness straps.
Release one safety harness strap from the T-shaped
yoke (P) located behind the backrest of the car seat.
Pull out the strap from the backrest.
Pull out the metal yoke (O) from the backrest.
Repeat these steps with the other strap.
Remove the fabric.
Repeat the steps above in reverse order to place the
cover back on the child seat.
Warning: after placing back the cover, carefully check the
straps (N) and padding (L) have been fitted in properly.
Follow the washing instructions reported on the label
attached to the fabric.
Wash plastic parts using warm water and soap. Do not
use aggressive detergents.
Warning: The covers are an integral part of the child seat:
the seat must not be used without the covers. The covers
must only be replaced with original spare parts.
For a lower environmental impact, we recommend
disposing of the parts by following the guidelines
provided by your local authority. Check the detailed list
of the materials used (fig. 1).
Warranty
Warranty terms and conditions are available on the
website: www.bellelli.com.
10