Velleman HAA2850 Bedienungsanleitung Seite 11

Keypad settings
attempts
5~10
00
Door forced-open alarm
Output activation announcer
User code entry mode (only applicable in multi-user mode)
Key-press acknowledge tones
Door open time-out
0
1 ~ 999
exit programming mode
information is saved and the keypad returns to normal working mode
Note: in case an error was made during programming, press the
or simply wait for 10s and try again.
26.02.2010
after 10 successive wrong codes the keypad locks for
30s (default)
after 10 successive wrong codes, the duress output
[f] switches to ground
after 5 to 10 successive wrong codes the keypad locks
for 15min – use the master code to reset at any time
reset above keypad settings
door forced-open alarm enabled
door forced-open alarm disabled (default)
notifying beep (1s) is given to notify the person outside to
open the door when output relay is activated via a user
code or egress button (default)
notifying beep disabled and replaced by 2 short successful
code entry beeps for valid user codes
auto entry mode selected;
user code (user codes must have the same length as the
master code)(default for single-user mode)
manual entry mode selected;
user code (user codes length can differ from the master
code length) (default for multi-user mode)
key-press tones enabled (default)
key-press tones disabled
no door-open time-out (default)
alarm will be triggered when the door remains open
longer than the set time (1~999s)
HAA2850
is not required after entering
11
is required after entering
Rev. 03
button,
©Velleman nv