Note: make sure to change the master code to 4 digits prior to switching
from multi-user to single-user mode.
•
The system takes about 3 seconds to rest; do not enter any code before
the 2 confirmation beeps are heard.
Resetting the master code
•
In case the master code is lost, use following procedure.
•
Open the keypad (see §6).
Be very careful, touching live wires can cause life-threatening
electroshocks.
•
Disconnect the power supply and set the DAP (Direct Access to
Programming) jumper [5] to the ON-position.
•
Reconnect the power supply; the buzzer will sound.
•
Place the DAP jumper [5] back in the OFF-position. This puts the keypad
in programming mode.
•
Close the keypad (see §6).
•
Set a new master code.
10. Technical specifications
colour
IP rating
user PIN codes output 1
user PIN codes output 2
dual relay output
output 1
output 2
power supply
dimensions
weight
Use this device with original accessories only. Velleman nv cannot
be held responsible in the event of damage or injury resulted from
(incorrect) use of this device. For more info concerning this product
and the latest version of this manual, please visit our website
www.velleman.eu. The information in this manual is subject to
change without prior notice.
© COPYRIGHT NOTICE
This manual is copyrighted. The copyright to this manual is owned
by Velleman nv. All worldwide rights reserved. No part of this manual may
be copied, reproduced, translated or reduced to any electronic medium or
otherwise without the prior written consent of the copyright holder.
26.02.2010
HAA2850
charcoal
IP66
100
10
NO & NC dry contacts
5A relay dry contact NO & NC
1A aux output relay NO & NC
12VDC or 24VAC (not incl.)
125(H) X 79(W) X 46~54(D)
520g
13
Rev. 03
©Velleman nv