Operating Instructions; Switching On The Appliance; Setting Temperature - OK. OFR10011A1 Bedienungsanleitung

EN
6

Operating instructions

Clean appliance prior to initial operation
The appliance and the parts of the interior have to be cleaned thouroughly before first
use. See also chapter ‚Cleaning and care'.

6.1 Switching on the appliance

DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE FRIDGE.
Operating tips
■ After the appliance has been switched on, it may take several hours until
the set temperature has been reached. Do not put any food in the appliance
beforehand.
■ The sides of the housing are sometimes heated slightly. This prevents
condensation in the area of the door seal.
■ The coolant fluid needs time to settle. If the appliance is switched off at any
time, wait 30 minutes before switching back on to allow the coolant fluid to
settle.

6.2 Setting temperature

Testing
Clean the parts of the refrigerator with lukewarm water containing a little neutral
detergent and with clear water, and wipe them dry.
Notes: Electric parts of the refrigerator can only be wiped by dry cloth.
1. Remark: turn the thermostat knob to the "4" position, turn on electricity. The
compressor begin to work..
2. Open the door 30 minutes later, if the temperature in the refrigerator decreased
obviously, it shows that the refrigerator system works well. When the refrigerator
operates for a period of time, the temperature controller will automatically set the
temperature within limits it opens.
OFR 10011 A1 Version OK1.0 04/2015 page 11 of 21