Installation - OK. OFR10011A1 Bedienungsanleitung

WARNING
Do not cut adhesive strips with a sharp object, e.g. a carpet knife,
the door gasket may be damaged.
After transportation allow the appliance to stand for 12 hours so that the cooling agent
can be collected in the compressor. Non-observance could damage the compressor
and hence result in failure of the device. This would void your warranty claim.
Packaging material
Ensure the environmentally sound disposal of packaging materials, see chapter 1.

4.1 Installation

Location
The ambient temperature affects the power consumption and the proper functioning of
the appliance. Therefore, install the appliance in a well-ventilated, dry room should. Its
ambient temperature should correspond with the climate class, for which the device is
designed for.
Do not install the appliance outdoors (e.g. balcony, terrace, garden house, etc.).
Regarding location of the appliance see also chapter 12 'tips for saving energy'.
For information on the climate class, please refer to the 'product data sheet' or the
rating plate, which is located on the rear or inside the appliance behind the vegetable
drawer. After installation the plug must be accessible.
Climate class and ambient temperature are as follows:
SN 10 to 32°C
The airflow on the rear and top affects energy consumption and cooling/freezing
capacity (depending on the model). Therefore the ventilation cross-section minimum
for the ventilation of the appliance must be observed. Please refer to the below listed
tables and drawings.
OFR 10011 A1
N 16 to 32°C
Version OK1.0 04/2015
EN
ST 16 to 38°C T 16 to 43°C
page 8 of 21