Trouble Shooting - Respekta 9040 Bedienungsanleitung

MALFUNKTION
The appliance
does not work at
all.
LED does not
work at all.
Light is on but
engine does not
work
The engine
smells doubtful
Smear of oil
Appliance
judders
Insufficient
extracting
capacity
Light does not
work
Appliance is
unstable
If the hood does not work properly and/or you can hear increased operating noise, check the
incorrect dimension of the air duct.
obstruction in the air duct.
the diameter of the air duct from hood to wall-box inclusive should add up to 150 mm;
otherwise the capacity of the engine may be decreased.
if you have installed a fly screen on the wall-box, the air vent may be obstructed.
Check by removing the fly screen.
if the cover panel of the wall box is equipped with firm and sloping slats, the air vent
may be obstructed. Check by removing the cover panel.
install a cover panel with moveable slats, which do not obstruct the air vent.
check condition and cleanness of the filters.
check if the air which is extracted by the hood is compensated to avoid negative
pressure.

8. TROUBLE SHOOTING

POSSIBLE CAUSE
The plug of the appliance is not
connected to the socket.
The plug has become loose.
The socket is not supplied with
energy.
The fuse is switched off.
ventilation damper blocked
condenser defective
engine mounting defective
engine defective
one-way valve is leaky
connection base chimney-
telescopic chimney is leaky
engine not properly fixed
hood not properly fixed
too much distance hood-hob
too much draught because of
open doors and/or windows
illuminate is defective
mounting rail is not firmly fixed
screws are not firmly screwed
down
schedule given below:
52
MEASURE
Check the
corresponding socket
by connecting it with
another appliance.
Check the fuse.
The voltage is too low.
Compare the data on
the model plate with
the data of your energy
supplier.
remove blocking
replace condenser
replace engine
replace engine
seal the valve
seal the connection
with a suitable material
fix engine properly
fix hood properly
lower position of hood
close the
doors/windows
Contact the after sales
service.
fix mountain rail
properly
screw down the screws