Electrical Connection - Respekta 9040 Bedienungsanleitung

A Air duct
1. Position the suspension device on the wall. Choose a proper position which meets
the dimensions of the chimney.
2. Mark the position of the drillings.
3. Now drill the holes and fix the suspension device with the screws and dowels.
4. Suspend the hood.
5. Now connect the exhaust hose to the corresponding outlet of the hood.
6. Install the exhaust hose to the corresponding outlet ( look at figure above A/B ).
7. Now fix the back brace of the chimney on the chimney.
8. Now fix the complete chimney on the hood.
9. Fix the mounting rail of the chimney at the desired position on the wall with the
screws and dowels.
10. Pull the telescopic part to the mounting rail and fix it on the rail.
11. Put in the plug and insert the grease filters.
An electrical supply of 220-240V AC / 50 Hz is required. Only use a suitable and
properly grounded socket near the appliance.
For your personal safety, the appliance must be grounded. The appliance is equipped
with a 3-phase grounding plug. Use a suitable socket to minimize the risk of an
electric shock.
Before you switch your appliance on, check if the voltage of your energy supplier
meets the values on the model plate.
Do not connect the appliance to the mains if the values of the model plate do not
meet the values of your energy supplier.
If the appliance is not equipped with a plug, you must install a 2-pole plug which
meets all legal requirements with a contact opening of at least 3 mm. The installation
must be performed by an authorized professional.

Electrical connection

44
B Through a wall