Indicator Lights - Symbol LS 7708 Kurzreferenz

4
LS 7708 Quick Reference Guide

Indicator Lights

The scanner employs an LED with a combination of red and green lights to
indicate operation and decode status. The Standard LED Definitions Table
on page 13 lists the different light combinations and their meanings.
If the scanner is not operating normally, contact the technical person in
charge of scanning, or call the Symbol Support Center at the telephone
number on the back cover.
Controls
The Volume Control & Wakeup button adjusts the volume of the beeper and
wakes the scanner from rest or sleep mode.
When the scanner is operating, depress this button to adjust the volume. Hold
down the button until the desired volume is obtained (approximately five
seconds). There are three volume levels. The scanner beeps twice at each
volume level before cycling to the next.
If the scanner is in a rest or sleep mode, briefly depressing the Volume Control
& Wakeup button also awakens the scanner.
Connections
The scanner's ports are at the bottom of the scanner. Turning the scanner
upside down allows access to the scanner's ports.
Host Port
Secondary Scanner
( )
Synapse Port
Power Port
RS-232 Aux Port EAS Interlock Port