Additional Safety Rules - Makita 3901 Betriebsanleitung

14. Maintain tools with care
Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating
and changing accessories. Inspect tool cords
periodically and, if damaged, have repaired by
authorized service facility. Inspect extension
cords periodically and replace if damaged. Keep
handles dry, clean and free from oil and grease.
15. Disconnect tools
When not in use, before servicing, and when
changing accessories such as blades, bits and
cutters.
16. Remove adjusting keys and wrenches
Form the habit of checking to see that keys and
adjusting wrenches are removed from tool before
turning it on.
17. Avoid unintentional starting
Don't carry plugged-in tool with finger on switch.
Be sure switch is off when plugging in.
18. Outdoor use extension cords
When tool is used outdoors, use only extension
cords intended for use outdoors and so marked.
19. Stay alert
Watch what you are doing. Use common sense.
Do not operate tool when you are tired.
20. Check damaged parts
Before further use of the tool, a guard or other
part that is damaged should be carefully checked
to determine that it will operate properly and per-
form its intended function. Check for alignment of
moving parts, binding of moving parts, breakage
of parts, mounting, and any other conditions that
may affect its operation. A guard or other part
that is damaged should be properly repaired or
replaced by an authorized service center unless
otherwise indicated elsewhere in this instruction
manual. Have defective switches replaced by
and authorized service center. Do not use tool if
switch does not turn it on and off.
21. Warning
The use of any other accessory or attachment
other than recommended in this operating
instruction or the catalog may present a risk of
personal injury.
22. Have your tool repaired by an expert
This electric appliance is in accordance with the
relevant safety rules. Repairing of electric appli-
ances may be carried out only by experts other-
wise it may cause considerable danger for the
user.
8

ADDITIONAL SAFETY RULES

1.
Hold tool by insulated gripping surfaces when
performing an operation where the cutting tool
may contact hidden wiring or its own cord. Con-
tact with a "live" wire will make exposed metal
parts of the tool "live" and shock the operator.
2. Use only the blades specified for this tool.
3. Never operate the tool with the blade locked
in exposed position or without the blade
cover secured properly in place.
4. Make sure that the blade slides smoothly
before operation.
5. Check the blade for cracks or damage before
operation. Replace cracked or damaged
blade immediately.
6. Make sure that the flange fits in the arbor
hole when installing the blade.
7. Inspect for and remove all nails or foreign
matter from the workpieces before operation.
8. Always place the workpieces on a stable
workbench.
9. Secure the workpieces firmly with clamp or
vise.
10. Never wear gloves during operation.
11. Hold the tool firmly with both hands.
12. Keep your hands and body away from the
cutting area.
13. Run the tool for a while without the blade
pointing toward anybody. Watch for vibration
or wobbling that could indicate poor installa-
tion or a poorly balanced blade.
14. Never reach your hands underneath the
workpieces while the blade is rotating.
15. Do not leave the tool running unattended.
16. Always be sure that the tool is switched off
and unplugged before making any adjust-
ments or replacing the blade.
17. Do not use blunt or damaged disk cutters.
18.
Do not use the tool with damaged guards.
SAVE THESE INSTRUCTIONS.
ENB060-2