Faber Jolie RB Gebrauchsanleitung Seite 5

Controls
L
Button Function
L
Turns the lights on/off at maximum strength.
Press and hold the button for approximately 2 seconds to turn the Courtesy Lights On/Off.
T1
Turns the motor on/off at speed one.
T2 Turns the Motor on at speed two.
Press and hold the button for approximately 5 seconds, with all the loads turned off (Motor
and Lights), to turn the Activated Charcoal Filter alarm on. The relevant LED flashes twice
to confirm.
To turn the alarm off, press the button again and hold for at least 5 seconds. The relevant
LED flashes once.
T3 Turns the Motor on at speed three.
Press and hold the button for approximately 3 seconds, with all the loads turned off (Motor
and Lights), to perform a reset. The LED S1 flashes three times.
T4 Turns the Motor on at INTENSIVE Speed.
This speed is timed to run for 6 minutes. At the end of this time, the system returns
automatically to the speed that was set before. If it is activated with the motor turned off,
the hood will switch to OFF at the end of the time.
Press and hold for 5 seconds to enable the remote control, indicated by the LED flashing
twice.
Press and hold for 5 seconds to disable the remote control, indicated by the LED flashing
just once.
S1 Signals the Metal Grease Filter saturation alarm, indicating that it is necessary to wash the
filters. The alarm is triggered after the Hood has been in operation for 100 working hours.
(Reset see the parag. Maintenance).
When this is activated, it signals the Activated Charcoal Filter saturation alarm, indicating
that the filter must be changed; the Metal Grease Filters must also be washed. The
Activated Charcoal Filter saturation alarm comes into operation after the Hood has been
working for 200 hours. (Activation and Reset see the parag. Maintenance)
Lighting
• For replacement contact technical
support. ("To purchase contact
technical support").
T1 T2 T3 T4
S1
Led
-
-
Fixed.
Fixed.
Fixed.
Fixed.
Fixed.
Flashing.
5