Makita 2712 Bedienungsanleitung Seite 7

− Hex bolt for guide rail (4 pcs)
− Guide rail (long) (1 pc)
− Guide rail (short) (1 pc)
− Sub table (1 pc)
− Stay (long) (2 pc)
− Stay (short) (2 pc)
− Hook (1 pc)
− Blade guard (1 pct)
− Tapping screw (3 pcs)
− Hex bolt (38 pcs)
− Hex nut (38 pcs)
− Hex wrench (1 pc)
− Wrench (1 pc)
− Push stick (1 pc)
− Push block (1 pc)
− Fence (for Rip fence) (1 pc)
− Rip fence (1 pc)
Installing table saw
1. Overturn the table saw on two boards. Check the
riving knife positions the space between two
boards.
1. Board
2. Riving knife
014597
2. Attach the four legs to the inside of base edge.
Attach the leg with the hole for the switch to the
side with the sign "A" on the base. Secure the
four legs temporarily, do not tighten the screws
firmly yet.
1
2
3
1. Leg
2. Switch hole
3. Sign A
014566
3. Attach the leg supports (long) to the legs and
then attach the leg supports (short) to the legs.
Secure the legs and leg supports with the screws
firmly. Always check the direction of support legs.
4. Install the feet at the bottoms of the legs. Secure
them with countersunk screws and hex nuts.
3
1
1. Leg support (long)
2. Leg support (short)
3. Foot
4. Wider side
014567
5. Install the tire complete to the legs and secure
them with screws and hex nuts.
Fig.1
6. Install the dust nozzle.
7. Adjust the motor part to the 0°position and secure
it by tightening the knob. Secure the power cord
with the cord clamp.
7
1
2
1
2
2
4