Technical Data; English - jbc 55N PULSMATIC Handbuch

We would like to thank you for the trust you have shown in JBC in acquiring our
soldering iron with its solder feed system. It has been made to the highest quality
standards to provide you with the best service.
Before using this equipment, we recommend you read these instructions carefully.
TECHNICAL DATA
55 N 230V Ref. 2552016
- Power supply: 230 V
- Power: 30 W
- Maximum temperature: 410°C
- Time to reach 250°C: 2 min.
Includes the following:
- Long-life tip C20D Ref. 0550509
- Replacement reel
This product should not be thrown in
the garbage.
INSTRUCTIONS FOR USE
Check that the mains voltage is the same as
specified on the unit.
Do not plug in the soldering iron without a tip,
as this might damage the element.
To avoid incidents, the hot soldering iron should
be kept inside the TS 1200 holder stand (Ref.
0290120), which is available as an extra.
REPLACING THE REEL
The reel is pressed into the support arm, where
it is held in place.
To extract the reel, rest the shaft end on a
convenient surface and press down on the
reel until it gives in.
Before fitting a new reel, pull out the solder
remaining inside the guide tube.
The solder flux may cause clogging at the
end of the guide tube: clean when necessary.
To fit the new reel, position it in such a way
that the solder wire runs off at the bottom;
insert the end of the wire into its hole and
feed it in until it becomes engaged in the
feed mechanism.
Always use solder wire of 1 mm in diameter.
SOLDER REEL TYPES:
- Solder reel with ø1mm solder wire. Alloy:
99%Sn / 0.3%Ag / 0.7%Cu - 50gr. Green
solder reel. SN5450
1

ENGLISH