Technical Specifications; English - jbc IN 2100 Bedienungsanleitung

We appreciate the trust you have shown in JBC by purchasing this IN 2100 Ref.
2132058, soldering gun. It has been manufactured with the highest standards of
quality to ensure reliable service.
It is equipped with a long life tip. See the models on the last page.
APPLICATIONS
Soldering of electronic components for
home repair calls or for use as a source of
quick and powerful heat.

TECHNICAL SPECIFICATIONS

- Power supply:
- Initial power:
- Maintenance power:
- Fast heating
reaches 250°C: in approx. 45 seconds
- Long-life tip T-20D:
- Weight:
This product should not be thrown in the
garbage.
OPERATING INSTRUCTIONS
Check that mains voltage is the same as
indicated on the soldering gun handle.
Plug in the soldering gun and press the
trigger without releasing for about 30
seconds. The temperature will keep rising
by its own inertia. Then press the trigger at
intervals of approx. 10 seconds to maintain
temperature.
If the soldering job requires high
temperature or if a great deal of heat
dissipation is foreseen (ground solder),
make an initial contact of approx. 1 minute,
then press the trigger again, this time for as
long as the soldering gun tip remains in
contact with the point to be soldered.
Do NOT keep the trigger pressed for the
whole time that the soldering gun remains
in operation or the tip will overheat and
wear out quickly.
Remember that the soldering flux
evaporates at very high temperatures
before its cleaning action has time to take
effect, thus failing to do the job for which it
is intended.
The coil spring which is supplied with the
unit serves as protection when storing the
hot soldering gun (Fig. 1) and as support
while working (Fig. 2).
230 V
200W
60W
Ref. 0300509
150 g
1
Fig. 1
Fig. 2

ENGLISH