HANSGROHE Focus S series Montageanleitung Seite 16

Important! The fitting must be installed, flushed
and tested after the valid norms!
Assembly
1. Flush through the supply pipes.
2. Mount the S - unions and align them.
3. Fasten the mixer with the washers.
The hot and cold supplies must be of equal
pressures.
Assembly
The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
31742000/31754000 The flow is changed from
bath to shower function by pulling the knob at the
upper side of the spout. After shutting off the
water flow, the mixer returns automatically to the
bath function.
Technical Data
Operating pressure:
Recommended operating pressure:
MPa
Test pressure:
(1 MPa = 10 bars = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Centre distance:
Connections G ½":
anti-pollution function
4
English
Max. 1 MPa
0,1 – 0,5
1,6 MPa
max. 80° C
65° C
cold right - hot left
To adjust the hot water limiter on single lever
mixers, please see page 6.
No adjustment is necessary when using a
continuous flow water heater.
Hansgrohe single lever mixers can be used
together with hydraulically and thermically
controlled continuous flow heaters if the flow
pressure is at least 0,15 MPa.
Important!
The non return valves must be checked once a
year.
Spare parts see page 3
1 handle
1.1 screw cover
2 flange
3 nut
4 cartridge cpl.
5 flange
6 S-union
7 aerator cpl.
8 selector assy
9 diverter knob
10 non return valve
31793000
96338000
97406000
97209000
92730000
94135000
94140000
13956000
94077000
94078000
94074000