Technical Specifications - Beper 50.600 Betriebsanleitung

Robot Cleaner Use instructions
EASY PROBLEM SOLUTIONS TABLE
PROBLEM CONTENTS
The appliance can't suck the dust
The appliance can't switch on
The appliance doesn't move on the
floor

TECHNICAL SPECIFICATIONS

Lithium Battery: 2000 mAh-7.4V
Adaptor
INPUT: 110-240V 50/60Hz - OUTPUT: 9V - 500 mA
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted municipal
waste stream. Old appliances must be collected separately in order to optimize the recovery and
recycling of the materials they contain, and reduce the impact on human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you
dispose of the appliance, it must be separately collected.
POSSIBLE CAUSE
1.The dust collecting box is full
2. The filter is not placed cor-
rectly
The battery is low
1.There could be water on the
floor
2.The wiping cloth is wet
3.The wiping cloth is wrongly
placed
12
SOLUTION
1. Clean the dust collecting box
2. Assemble the filter into the dust
collecting box correctly
Charge the battery and try to
switch on again
1.Dry the floor
2.Wipe and dry the wiping cloth.
3. Assemble the wiping cloth
again.