Product And Accessories; Technical Data - Beper EcoFlow 50.400 Betriebsanleitung

Rechargeable Vacuum Cleaner Use instructions
Accessories and filter must only be mounted or disassembled when the appliance is switched off. The liquid filter
should only be mounted when it is completely dry.
If the appliance overheats or produces burnt smell during use; If it produces noises other than usual, it is sugge-
sted to turn it off and check that the is not clogged.

PRODUCT AND ACCESSORIES

1. Charging station/wall holder
2. Liquid and solid container
3. Release button
4. ON / OFF switch
5. Recharge indicator led light
6. Engine Body
7. Charging adapter
8. Brush
9. Crevice nozzles
INSTRUCTIONS FOR USE
When using the appliance for the first time, let it charge for some hours so the batteries can charge complete.
Press the release button (3), remove the liquid and solid container (2) and check that the suction filter is securely
fastened.
Insert the desired accessory into the suction nozzle.
Press the ON / OFF button (4) and vacuum the material by approaching the suction nozzle.
At the end, switch off the appliance by pressing the ON / OFF button (4) again.
Empty the container after vacuum liquids and / or solids, or when the container (2) is full, by pressing the release
button (3).
CLEANING
Switch off the appliance before cleaning it.
The outer body, the container, the suction accessories can be cleaned with a soft cloth dampened with hot water.
Do not clean with diluents, abrasive products, detergents for plastic or other; could damage the surface.
Take care not to penetrate liquids inside the slots of the appliance.
The filter can be wash by rinsing it under tap water, but before reassembling it must be completely dry.
RECHARGE
Switch off the appliance with the ON / OFF button (4).
Plug the adapter plug into an AC 230 V - 50 Hz AC socket.
The charging LED (5) on the body lights up signaling the charging phase.
Do not recharge for more than 8-10 hours.
When charging is complete, disconnect the plug and store the base in a dry place.
For charging use only the supplied original adapter and do not modify the power cord or any other part of the
adapter.

TECHNICAL DATA

Power: 60W
Mains adapter:
Output DC 7.2V
Input AC 230-240V ~ 50Hz
Battery: AA Ni-MH 7.2V 1400mAh
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
9
EN