HPE StoreOnce 5500 System Kurzanleitung Seite 6

If 10GbE SFP Network or Fibre
NOTE:
Channel cards are pre-installed, fit the
appropriate SFP+ transceivers, as described
in the HPE StoreOnce 5500 System
Installation and Configuration Guide.
Step 9: Connect the iLO port
(recommended)
Step 10: Power up
1. Perform a final check to ensure all cables are
connected correctly and securely:
Head server unit
Two power cables to the head server
Keyboard and monitor cables
Network cable to LAN port 1
Network cable to iLO port
Optional hardware — see the StoreOnce
10 GbE Network Card and StoreOnce
Fibre Channel Card Installation and
Configuration Guide
Disk enclosure(s)
Four power cables to the disk enclosure
Two 2m SAS cables from the disk
enclosure to the first RAID controller card
(slot 2)
Two 0.5m SAS cables between the
drawers on the disk enclosure
2. Power on all installed disk enclosures first. You
may need to hold down the power on button
(1) on the rear of each unit for up to 30
seconds. Look at the LEDs on the I/O modules
and wait until the Green Status LED (3)
remains on, and the Locate LED (2) and the
Fault LED (4) are both off.
1
Page 6
2
3
4