On-Timer Operation - Mitsubishi Heavy Industries SRF35ZJX-S Anwenderhandbuch

ON-TIMER operation

■ Operation starts 5 to 60 minutes before the set time so that the room temperature reaches the optimum temperature at the set time.
ON-TIMER operation can be set regardless of whether the air-conditioner is running or not.
Changing of set time
Set a new time by using the ON-TIMER button.
How to cancel
Press the CANCEL button to turn off the timer
indicator.
Comfort Start-up
In ON TIMER operation, the unit starts the operation a little earlier, so that the
room can approach optimum temperature at ON time. This is so called
"Comfort start-up".
• Mechanism
The room temperature is checked
60 minutes before the ON time.
Depending on the temperature at
that time, the operation starts 5 to
60 minutes before the timer is at
ON.
• The function is available for both
COOL and HEAT operation
mode (including AUTO). It does
not work for DRY mode.
1
2
3
• Operation starts 5 to 60 minutes before the set time.
• The timer light (yellow) goes out at the set time.
• Make sure to press the button within 60 seconds from the last operation in step 2,
otherwise the setting is not completed.
• The current time is not displayed during ON-TIMER operation.
In COOL operation
(Stop) Operation starts
(Operation)
Set temperature
Check the room Set time
temp. 60 mins.
before.
Example: In the case the preferred room temperature is required at 8:00.
Press the ON-TIMER button.
ON TIMER indicator is blinking.
Press the " or " button.
Every time the button is pressed, the display is switched in the order of:
...
0:00 0:10 0:20
Every time the button is pressed, the display is switched in the order of:
... 23:00
0:00 23:50 23:40
Set at 8:00.
Press the ON TIMER button.
The display changes from blinking to steady lighting and the setting is complete.
The timer light (yellow) is on.
The operation stops if it is set during operation.
NOTE
Unit display section
– 13 –
(Units of ten minutes)
1:00 1:10
(Units of ten minutes)
22:50
TIMER light (yellow)