Inhaltsverzeichnis
Werbung
cleaning the shaving head (HP6483 only)
Clean the shaving head after every use.
1
Make sure the appliance is switched off and disconnected from the
mains.
Remove the shaving head (Fig. 1).
Press the release button (1) and pull the shaving head of the appliance
(2).
Pull the cutter unit out of the shaving head. (Fig. 1)
Brush the hairs off the cutter unit and the shaving head with the
cleaning brush. (Fig. )
Make sure that you also brush away any hairs that have collected under
the trimmers.
5
You can also rinse the cutter unit and the shaving head (not the
appliance!) under the tap (Fig. ).
6
Put the cutter unit back into the shaving head and snap the shaving
head back onto the appliance ('click') (Fig. ).
Do not exert pressure on the shaving foil to avoid damaging it.
7
Rub a drop of sewing machine oil onto the trimmers and shaving
foil of the cutter unit twice a year.
storage
1
Put the protection cap on the shaving head ('click'). (Fig. 5)
Store the appliance and the accessories in the pouch.
replacement (HP6483 only)
If you use the shaving head several times a week, replace the cutter unit
(type HP6193) after one or two years of use. Replace the cutter unit
right away if it is damaged.
EnglisH
1
Werbung
Inhaltsverzeichnis
