Line Input /Output Selection; Channel Memories - XIEGU G90 Benutzerhandbuch

Line Input /Output Selection

The G90 has an external line input interface.
Line Input Operations:
Input the external audio signal to the corresponding pin of the ACC port
(see the interface description section for pin definition).
Go to [FUNC + POW] second item INPUT and select: LINE
In the system menu, select: AUX IN VOLUME to set the appropriate
INPUT volume.
Line Output Operations:
In the system menu, select: AUX OUT VOLUME to set the appropriate
output volume.
NOTE: Line input audio level is ≥200mV MAXIMUM.
26
Channel storage:
1. In the VFO mode, adjust the required frequency, mode and other parameters;
2. Press the [MW/MC] button momentarily and the CH 00 (channel number)
character will appear on the screen flashing. Rotate the main knob to select an
empty channel. A character E will appear after the channel number, indicating
that the channel is empty and can be used.
3. Press the [MW/MC] button again to save the current set frequency information
to the selected channel.
Using Memory Channels:
1. Press the [VM] button on the panel in VFO mode to enter channel memory
mode; (alternates VFO/Mem)
2. Rotate the main knob to switch to select memory channels. (or use mic
up/down buttons)
Clearing a memory channel:
1. In channel mode, press [FUNC] then [MW/MC], at which point the channel
number starts to flash;
2. Turn the main knob to adjust to the channel you want to clear. Press the
[MW/MC] button again to clear the selected channel.

Channel Memories

27