Operating Mode Selection; Volume Adjustment - XIEGU G90 Benutzerhandbuch

+
[MODE]
Each amateur band has a user-defined frequency range associated with it.
The radio will be configured to allow 60 meter band operation if your country
permits it.
VFO-A and VFO-B are two independent VFO's that can be set independently.

Operating MODE Selection

Pressing the [ MODE ] button increments through the available operating modes.
Mode left loop
[MODE]
The FM mode can only be turned on when used with the GSOC controller.
-
[BAND]
Mode right loop
[BAND]
14
Speaker mode:
Rotate the volume knob left or right to
adjust the level of received volume.
Headphone mode：
Press the volume knob inwards momentarily
to enter headphone mode and mute the speaker.
Rotate the volume knob left or right to adjust the
level of the headphone volume.
VOX mode on / off：
Press and hold the [FUNC] button for over 1 second.
Press the volume knob briefly to enter the VOX function settings.
VOX menu description:
VOX OFF/ON: VOX function off/on
VOX GAIN: Voice Control Gain Setting
ANTI-VOX: Hand mic speaker noise-trip suppression setting
VOX DLY: VOX hold delay setting
The voice control function can be enabled for both the hand microphone and
the line input LINE.
This is handy for use when you only connect the RX and TX audio lines to the Acc.
This will Key the G90's TX key the radio automatically using digital modes.
(no CAT required).
When using the AF IN port of the ACC interface for line input audio, set the
appropriate input volume level in the system menu.
This will have an effect on the VOX level setting- so set it first.

Volume Adjustment

15