Assembly; Pulling Out The Table Top - FLORABEST HG04392A Bedienungs- Und Sicherheitshinweise

RISK OF DAMAGE TO
PROPERTY! We are not liable
for accidents that occur as a
result of non-observance of the
above safety notes or through
incorrect handling.

Assembly

1. Place the table top
flat surface, with the underside
facing upward.
Note: Hard surfaces may cause
scratching on the table top.
2. Twist the four rods
tapped holes
(Fig. B).
1
Note: Please ensure that you
screw the rods
table top thread
3. Slot the table legs
rods . Please ensure that the
3
end of the rod protrudes through
the hole in the table leg
2a
(Fig. C).
4. Place one washer
ring , and one nut
5
end of each rod (Fig. D).
5. Insert the tool bar
hole in the tool sleeve
9a
(Fig. D).
6. Fasten the nut
sleeve (Fig. D) and add a
9
14 GB/IE
on a soft,
1
into the
3
of the table top
1a
tightly into the
3
.
1a
onto the
2
2
, one lock
4
on the
6
into the
10
9
with the tool
6
foot cap ,
7
each leg (Fig. E).
2
7. Turn the table carefully over and
set it on the legs.
Note: The table must be turned
over by two people.
8. Adjust the table leg using the
height adjustment
achieve optimum stability (Fig. F).

Pulling out the table top

You can extend the table top
. Please follow these steps:
1
1. Press the button
side of the table top
2. Carefully slide out the lateral ta-
ble panels
1c
plastic wing nut (Fig. H).
3. Turn the middle panel
underneath the table frame (Fig. I).
Note: If necessary, push the
two lateral table panels to the
middle panel to get a level surface.
4. Press on the adjustment button
until it audibly engages (Fig. H).
Slide the table panels
gether.
To push the table top back
together, follow these steps:
1. Press the button
side of the table top
to the base of
8
in order to
8
on the under-
1b
(Fig. I).
1
and unlock the
located
1d
, to-
1c 1d
on the under-
1b
(Fig. G).
1
1e