Bosch TCE 5210 Instandsetzungsanleitung Seite 18

en 18 | TCE 5210 |
Contents
1. Symbols Used
1.1 Documentation
1.2 TCE 5210
2. Malfunction
3. Adjustments
3.1 Test and change of the rotation direction of the
electric motors
3.2 Hydraulic panel electrovalve release
3.3 Hydraulic panel electrovalve replacement
3.4 Adjustment and replacement of the mandrel rota-
tion belts
3.5 Greasing points
3.6 Adjustments of the hinges of the tool holding
arm
3.7 Three-phase electrical system
3.7.1 Q1 - main switch
3.7.2 F1, F2, F3 - protection fuses of the whole
high-tension circuit
3.7.3 Q3 - thermal-magnetic motor protector
for the protection of the motor and of the
hydraulic pump
3.7.4 F4 and F5 - protection fuses of the pri-
mary circuit of the tension transformer
(T 100VA)
3.7.5 F6 - protection fuse of the low-tension
24VDC circuit
3.7.6 F7 protection fuse of the 24VAC circuit 24
3.8 Single-phase electrical system
3.8.1 Q1 - main switch
3.8.2 F1 and F2 - protection fuses of the high-
tension circuit and of the mandrel rota-
tion motor
3.8.3 Q2 - thermal-magnetic motor protector
for the protection of the hydraulic pump
motor
3.8.4 F4 and F5 - protection fuses of the pri-
mary circuit of the tension transformer (T
100VA)
3.8.5 F6 - protection fuse of the low-tension
24VDC circuit
3.8.6 F7 - protection fuse of the 24VAC
circuit
3.9 Replacement of the joystick of the control pedal
box.
3.10 Replacement of the pedal box cable and of the
entire pedal box
3.11 Replacement of the micro switch of the control
pedal box rotation mandrel
3.12 Replacement of the spring of the rocker arm of
the control pedal box rotation mandrel
3.13 Replacement of the tool arm trolley slides
|
1 695 400 317 2008-10-17
19 4. Hydraulic oils comparison table
19 4.1 Oil level check
19
20
21
21
21
21
22
22
23
23
23
23
23
23
23
24
24
24
24
24
24
25
27
27
28
29
30
31
31
Robert Bosch GmbH