Inhaltsverzeichnis
Werbung
d) Connect the red wire (+) to the positive terminal of the battery and the black (-) wire to the
negative terminal of the battery.
e) Connect the power cable to your CB radio.
WARNING: Never replace the original fuse by one of a different value.
4) BASIC OPERATIONS TO BE CARRIED OUT BEFORE USING YOUR SET FOR THE
FIRST TIME (without transmitting and without using the "push-to-talk" switch
on the microphone)
a) Connect the microphone.
b) Check the antenna connections.
c) Turn the set on by turning the volume knob VOL (1) clockwise.
d) Turn the squelch SQ knob (2) to minimum M.
e) Adjust the volume to a comfortable level.
f)
Go to channel 20 by using ROTARY knob (4) or UP/DN buttons (12) on the microphone.
5) HOW TO ADJUST SWR (Standing Wave Ratio)
Warning: This must be carried out when you use your radio for the fi rst time and whenever you
re-position your antenna. This adjustment must be carried out in an obstacle-free area.
*
Adjustment with external SWR-meter (e.g. TOS-1 PRESIDENT)
a) To connect the SWR meter :
-
Connect the SWR meter between the CB radio and the antenna as close as possible to the CB
(use a maximum of 40 cm cable, type President CA 2C).
b) To adjust the SWR meter:
-
Set the CB on channel 20 in AM.
-
Put the switch on the SWR-meter to position FWD (calibration).
-
Press the PTT "push-to-talk" switch (11) on the microphone to transmit.
-
Bring the index needle to
-
Change the switch to position REF (reading of the SWR level). The reading on the Meter should
be as near as possible to 1. If this is not the case, readjust your antenna to obtain a reading as
close as possible to 1. (A SWR reading between 1 and 1.8 is acceptable).
-
It will be necessary to recalibrate the SWR meter after each adjustment of the antenna.
WARNING: In order to avoid any losses and attenuations in cables used for connection between
the radio and its accessories, PRESIDENT recommends to use a cable with a length inferior to 3
m.
Your transceiver is now ready for use.
B) HOW TO USE YOUR TRANSCEIVER
ON/OFF ~ VOLUME
Turn n : turn VOL knob (1) clockwise. If the function KEY BEEP is active (see menu KEY BEEP page
20), the radio emits a beep. The radio is "on".
Display briefly shows the frequency band (see § FREQUENCY BAND SELECTION page 21).
Turn Off : turn VOL knob (1) counterclockwise until radio emits click sound. Your radio is "off".
Volume Adjustment: rotate VOL knob (1) clockwise to increase the volume. Turn the same knob
counterclockwise to reduce the sound level.
ASC (Automatic Squelch Control) ~ SQUELCH
Suppresses undesirable background noises when there is no communication. Squelch does not
affect neither sound nor transmission power, but allows a considerable improvement in listening
comfort.
a) ASC: AUTOMATIC SQUELCH CONTROL
Worldwide patent, a PRESIDENT exclusivity.
Turn the SQ knob (2) anti-clockwise into ASC position.
adjustment and a permanent improvement between the sensitivity and the listening comfort
by using the calibration key.
appears on LCD. No repetitive manual
Werbung
Inhaltsverzeichnis
