Preparing To Use Your Phone; Preparing To Use The Handset; Inserting The Batteries - Siemens Gigaset S1colour Bedienungsanleitung

Preparing to use your phone

The pack contains:
one Gigaset S1 colour handset, one charger, one belt clip for the handset, two batteries,
a power supply unit with power cord, one set of operating instructions.

Preparing to use the handset

The display is protected by a plastic film. Remove the protective plastic film!

Inserting the batteries

Insert the batteries ensuring correct polarity – see figure on left.
◆
Position the battery cover so that it is open by around 3 mm, then slide up until it
◆
closes with a click,
To open the battery cover, press on the chequered area and slide down.
◆
Use only the rechargeable batteries recommended by Siemens on
page 22! Never use conventional batteries (non-rechargeable) or other
W
battery types as this may cause significant damage to health and
property. For example, the jacket of the battery could be destroyed
(hazardous). The phone could also malfunction or be damaged.
Placing the handset into the base (registering) and charging the batteries
When you place the Gigaset S1 colour handset into the S 100 colour/S 150 colour, C 100/
C 150 or C 200/C 250 base, it will register to the base automatically. Proceed step by
step as follows:
1. Place the handset in the base with the display up.
2. Wait till the handset has registered automatically to the base: This operation takes
around one minute. While registration is in progress the screen displays
Regstr.Procedure and Base 1 flashes. When the handset has registered, the
internal number that is assigned to it appears in the display (e.g. 'INT 2').
3. Now leave the handset in the charger for the batteries to charge - the batteries are
supplied uncharged. Battery charging is indicated in the top right of the display by
the flashing battery icon × .
Preparing to use your phone
5