Programming F.gm In The F.ko Radio Control Unit - Seca F.BM Montage- Und Betriebsanleitung

Programming F.GM in the F.KO radio control unit

D
P ALARME STÖRUNG
1 Notruf Sensor
2
Brand Batterie
3
Gas Funk
1 4 Einbruch1
5 Einbruch2
6
Technik
R
Still Betrieb
Scharf 1 Störung
Scharf 2 Notstrom
64
1
Briefly press the zone button 4 = Break-in 1 or 5 = Break-
in 2.
The corresponding zone LED Break-in 1 or 2 flashes.
2
Now enter the detector's surveillance area to trigger an
alarm deliberately. If the Walk Test jumper is set at ON, the
Walk Test LED in the detector lights up when the instrument
goes into alarm.
The F.KO receives the alarm and its red zone LED comes on. If
the detector has been successfully programmed in the control
unit, the display shows the sensor number and after a few sec-
onds the reception signal strength (
= good,
If the F.KO zone LED flashes, the detector is located outside the
transmission range or no alarm has been given.
= very good ...
/ = critical).