FORGE ADOUR Modern Gaz serie Bedienungsanleitung Seite 25

Precautions for use
•It is recommended to wear protective gloves
when handling particularly hot components.
•The parts protected by the manufacturer
must not be handled by the user. None of
the gas line components are to be modified
by the user. The gas containers that can be
used on this type of appliance range from
6 to 13 Kg (Dimension, height: 560 mm and
depth: 310 mm max., pressure relief valve
included).
•Comply with the use-by dates of your hose,
and replace it if need be. Test the tightness
every time the hose is replaced.Check the
position of the connecting hose to ensure
that it is not in contact with the hot parts of
the appliance.
•Be sure to replace the container away from
any source of ignition.
•Do not plug the vents and regularly check
that they are clean. If the venturis are
clogged, contact the manufacturer or your
retailer.
•The underside of the appliance must remain
clear to allow for proper circulation of air to
the burner.
•Do not modify the appliance, contact the
manufacturer or your retailer.
•Before using your FORGE ADOUR plancha
after a period of storage and/or inactivity,
check it carefully in order to detect any gas
leak and/or clogging of the burners.
•Do not modify the appliance, contact the
manufacturer or your retailer.
•Before using your FORGE ADOUR plancha
after a period of storage and/or inactivity,
check it carefully in order to detect any gas
leak and/or clogging of the burners.
Directions for use
Lighting and operation of the plancha.
Before lighting your plancha, check that all
the conditions stated in the "PRECAUTIONS
FOR USE" section are met.
• Check that the control switch is on the « 0
» position as shown (Fig.1). Open the gas
supply (bottle for butane/propane, wall
valve for natural gas).
Control switch
Rotate the control switch counterclockwise
while holding it down on the ignition to
generate the sparks required for lighting
of the burners.
(Fig 2)
Control switch
• Keep the control switch down for at
least 5 seconds afer lighting the burner.
• The device must not be operated for
more than 15 seconds. If the burner has
not lit, stop acting on the device, open
the enclosure door and / or wait at least
1 minute before any further attempts to
ignite the burner
EN
25