FORGE ADOUR Modern Gaz serie Bedienungsanleitung Seite 22

Gas connection
Screw the hose fitting clockwise as shown in the drawing opposite.
The hose must be connected in accordance with the hose manufacturer's instructions, and in
compliance with the standards in force in the country concerned.
Your FORGE ADOUR plancha is configured to work with either Butane/Propane Gas or with
Natural Gas, depending on what you requested from your retailer on purchase.
The type of Gas to be used is written on the label on the side of your plancha.
The Butane/Propane Gas hoses are equipped with different-sized fittings, and are identified
by different colours. To prevent any risk of damage to the plancha fitting, please refer to
the instructions provided by the hose manufacturer.
Connection of your plancha in the I3+ category (Butane/Propane):
• Use an NF 28 mbar safety pressure relief valve for butane and NF 37 mbar for propane
• An NFD36-125 metallic hose or an XPD36-112 hose
Connection of your plancha in the I2+ category (Natural Gas):
For use with Natural Gas (G20/G25):
• Use an NFD36-121 metallic hose or an XPD36-103 hose.
The entire length of the rubber hose must be visible and easily accessible.
Comply with the safety instructions for use (e.g. use-by date, etc.) specified by the hose
manufacturer. The hose must not be longer than 1.5 meters.
Each burner is fitted with a thermocouple safety device which cuts off the gas supply to the
burners if the flame goes out unexpectedly.
All maintenance operations requiring the opening of the inner gas supply system must
exclusively be carried out by an authorized repairer. Any attempt to dismantle and modify
the appliance in order to change its technical characteristics may cause accidents for
which the manufacturer accepts no responsibility, and which will make the guarantee null
and void.
22