Cleaning And Care - Vitek VT-2312 Y Betriebsanleitung

VT-2312_IM_70x130.indd 6
ENGLISH
• Do not comb your hair right after styling, let it cool off.
Divide the locks with your fingers carefully to make them
look natural.
– Remove the protection cap (6).
– Insert the power plug into the mains socket.
– Switch the unit on by pressing the button (4)
– Set the temperature of the heating plates (1), using
the buttons (3) «+/-», the indicator (5) will be flashing.
Remember that the heating plates get hot faster than
they cool down.
Hair type
Damaged, colored,
bleached, fine
Normal
For professional styling
– Place the unit on a flat heat-resistant surface.
– When the heating plates (1) reach the set temperature,
the indicator (5) will glow constantly.
– Divide the hair into locks not wider than 4-5 cm each.
– Take the unit by the handle (2), take a hair lock with the
free hand.
– Place the hair lock between the plates (1) and press
them together. Slowly slide the hair straightener
throughout the hair length.
– You can curl the end of the lock; to do this, press the hair
between the heating plates (1) and wind the hair around
the outer operating surfaces. Wait for several seconds
and release the lock by opening the heating plates (1).
– After styling, press the button (4)
will go out.
– Unplug the unit.
– Place the unit on a flat heat-resistant surface and let it
cool down completely.
– Press the heating plates (1) together and put the protec-
tion cap (6) on.

CLEANING AND CARE

– Before cleaning, unplug the unit and let it cool down
completely.
Temperature
from +145°to +160°С
from +175°С to +190°С
from +205°С to +220°С
, the indicator (5)
6
.
28.07.2014 11:35:01