Flight Preparation - Pelikan Daniel MT-180H Bauanleitung

SLING mini
INTRODUCTION
Congratulation on your purchase of the SLING mini discus launch glider
(DLG). You are about to embark on a magical journey into the fascinating
world of RC aeroplanes. SLING mini manufactured of durable composite
and Styrofoam materials will help to become an experienced pilot in your
backyard!
FEATURES
• 100% factory-made, almost completely assembled model
• Elevator and rudder control
• Easy handling and high stability; durable
• State-of-the-art 2.4GHz FHSS four channel radio
SPECIFICATION
Wingspan 640 mm
Length 550 mm
Wing area 5.7 dm2
SET CONTENTS
• 100% factory-made, almost completely assembled model
• 2.4GHz transmitter
• 3.7 V/35 mAh LiPo receiver battery
SAFETY PRECAUTIONS
An R/C aeroplane is not a toy! If misused, it can cause serious bodily harm
and damage to property. Fly only outdoors following all instructions and
as recommended in this manual.
Note on Lithium Polymer Batteries
Lithium Polymer (LiPo) batteries are significantly more vulnerable than
alkaline or NiCd/NiMH batteries used in R/C applications. All manufactur-
er's instructions and warnings must be followed closely. Mishandling of
LiPo batteries can result in fire. Always follow the manufacturer's instruc-
tions when disposing of Lithium Polymer batteries.
Additional Safety Precautions and Warnings
• As the user of this product, you are solely responsible for operating it in
a manner that does not endanger yourself and others or result in dam-
age to the product or the property of others. This model is controlled by
a radio signal that is subject to interference from many sources outside
your control. This interference can cause momentary loss of control so

FLIGHT PREPARATION

Please Remember
• Always turn the transmitter on first. Only then plug the receiver (Rx)
battery to the model.
• At the end of your flying session unplug the Rx battery from the model.
Turn the transmitter off last.
• You must charge the included 3.7V 35 mAh LiPo battery in a safe area
away from flammable materials.
• Never charge the battery unattended. When charging the battery you
should always remain in constant observation to monitor the charging
process and react to potential problems that may occur.
Instruction Manual
WARNING: The wing and tail of this model are manufactured of
the microcell Styrofoam. This material may not be glued using
regular cyanoacrylate glues or exposed to any kind of organic
solvent or paint thinner. To repair damaged parts use clear sticky
tape, PVA(C) or epoxy glues please.
• Easy to change stick mode (Mode 1 and Mode 2)
• Small dimensions, extremely light
• Extra light LiPo receiver battery
• Fast charger built in the transmitter
All-up Weight
Flight Battery
You will need to purchase 4 AA alkaline batteries for the transmitter to
fly your aeroplane.
it is advisable to always keep a safe distance in all directions around
your model, as this margin will help to avoid collisions or injury.
• Never operate your model with low transmitter batteries.
• Always operate your model in an open area away from cars, traffic, or
people.
• Avoid operating your model in the street where injury or damage can occur.
• Never operate the model out into the street or populated areas for any
reason.
• Carefully follow the directions and warnings for this and any optional sup-
port equipment (chargers, rechargeable batteries, etc.) which you use.
• Keep all chemicals, small parts and anything electrical out of the reach
of children.
• Moisture causes damage to electronics. Avoid water exposure to all
equipment not specifically designed and protected for this purpose.
• Keep your model and any accessories out of the reach of children. There
are small parts that could be ingested or inhaled.
• You MUST use the included LiPo Charger built in the transmitter ONLY.
Failure to do so may result in a fire causing personal injury and/or prop-
erty damage.
• If at any time during the charge process the battery begins to inflate,
discontinue charging immediately. Quickly and safely disconnect the
battery then place it in a safe, open area away from flammable materi-
als to observe it for 30-45 minutes. Continuing to charge or discharge a
battery that has begun to balloon or swell can result in a fire. A battery
that has inflated even a small amount must be removed from service
completely.
3
65-80 g
3,7 V/35 mAh LiPo