Safety Notes; Installation Instructions; Symbol Description - HANSGROHE Massaud Montageanleitung

Safety Notes

Gloves should be worn during installation to prevent
crushing and cutting injuries.
The hot and cold supplies must be of equal pres-
sures.

Installation Instructions

• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be oberserved.
Assembly (see page 34)
• A: Plaster the installed and tested basic components,
or cover with panelling if installed on the exterior of
the wall.
After the plastered wall surface is dry, seal the gap
between wall and plastic sleeve of the flush valve with
silicone (free from acetic acid!).
• B: Apply PCI-Lastogum or similar sealing compound
on the wall in accordance with manufacturers indica-
tions.
• C: Put gasket over the plastic sleeve of the Quattro
four-way-diverter.
The gasket is not suitable for hot glue.
4
English

Symbol description

Assembly see page 32
Do not use silicone containing acetic acid!
Area for required wall reinforcement
Dimensions (see page 31)
Special accessories (order as an
extra)
sealing foil #96492000
Spare parts (see page 36)
Final assembly (see page 35)
Test certificate (see page 31)