Adjusting The Pressure Plate; Maintenance And Cleaning; General Cleaning And Servicing; Replacement Parts - FLORABEST FLH 2500 A1 Originalbetriebsanleitung

GB

Adjusting the pressure plate

The pressure plate factory setting is correct,
and only has to be adjusted with wear. You
will recognise that the cutting system has
become worn when the shredding material
is only compressed, and comes out in long
chains.
The running-in process may require that
you initially readjust the pressure plate in
short intervals.
1. To switch on the equipment, turn the
operating mode selection switch (
to the right.
2. Turn the adjusting screw (
clockwise until you hear scraping nois-
es. Small aluminium shavings will come
out of the ejection chute.
Avoid unnecessary wear on the
pressure plate by not over-adjust-
ing.

Maintenance and cleaning

Leave all work not described
in this manual to an authorised
customer service centre. Only
use original parts.
Wear hand protection when work-
ing on the blade cylinder.
Switch the shredder off, unplug it
form the mains, and wait for the
blade cylinder to come to a com-
plete stop before working on it.
12

General cleaning and servicing

•
•
9) •
A
11) slowly
A
•

Replacement parts

Replacement parts can be ordered direct-
ly from our service centre (see address on
page 93). In your order, quote the equip-
ment type and position number in the
exploded view.
Waste disposal and
environmental protection
Be environmentally friendly. Return the
tool, accessories and packaging to a recy-
cling centre when you have finished with
them.
Do not spray water onto the
shredder. Electric shock hazard.
Always keep the shredder, wheels and
air vents clean. Use a brush or cloth to
clean it, avoid cleaners and solvents.
Always check that the shredder and
especially the guards are not worn
down or damaged but firmly attached
before use. Check that the nuts, bolts
and screws are tight.
Check the covers and guards for dam-
age and improper attachment. If nec-
essary, change the components
Keep the shredder in a dry place out
of children's reach. Do not cover the
shredder in nylon bags, as moisture
may develop.
Machines do not belong with do-
mestic waste.