Adjusting The Pressure Plate - FLORABEST FLH 2800 B2 Originalbetriebsanleitung

e. Put the blade cover (22) back
and tighten the four screws (21)
8. Connect the power supply and
switch the shredder ON and OFF
(see " switching the shredder off
and on") to check.
Overload protection switch (11) not
motivated
D
1. Switch the shredder OFF
(see"switching the shredder on
and off ) .
2. Press the function switch (8)
upwards to allow the blade
rotate anti-clockwise to return the
material.
3. Press and hold the "ON" switch (9)
to start the machine to return the
jammed material.
4. Switch the shredder OFF and ON
(see" switching the shredder on
and off ) to check if the jam is
fixed.
5. If jam is fixed, switch the shredder
ON (see" switching the shredder
on and off ) to continue shredding
the material.
6. If jam is not fixed, repeat above
steps. If still fail to fix, open the
blade cover (22) to clean
the jammed material:
a. Unplug the power supply
b. Loosen the four blade cover
screws (21) by enclosed Allen
wrench.
c. Pull to remove the blade cover
(22)
d. Clean the jammed material
from the cylinder blade (23) and
pressure plate (24).
e. Put the blade cover (22) back
and tighten the four screws (21).
Connect the power supply and
switch the shredder OFF and ON
(see " switching the shredder on
and off") to check.

Adjusting the pressure plate

The pressure plate factory setting is correct
and only has to be adjusted when worn.
You will recognise that the cutting system has
become worn when the shredded material
is only compressed, and comes out in long
chains.
The running-in process may require that you
initially readjust the pressure plate (24) in
short intervals,
A
1. Check the funnel feeder (7) is
empty and clean.
D 2. Connect the power supply and
switch ON the machine to shred
the material(see" switching the
shredder on and off").
3. Turn the adjustor screw (4) slowly
clockwise until you you hear
scraping noises. Small aluminum
shavings will come out.
4. Switch OFF the machine and
unplug the power supply.
Avoid unnecessary wear on
the pressure plate by not over-
adjusting.
GB IE NI
109