Safety Notes - Monacor VTM-10 Bedienungsanleitung

1 Operating Elements and Connections
(page 2)
1.1 Front panel (fig. 1)
1 Status LEDs
POWER: power LED
CONVERSION: will light up in the converter mode
SIGNAL: will light up in the converter mode if a
video signal is available at the input selected
2 Button to call the OSD menu in the converter
mode; when the button
same time, the unit will be reset to the factory set-
tings
in the OSD menu: to select the submenus and to
change the settings
3 Button to switch between the converter mode
and the PC feed-through mode
in the OSD menu: to call a submenu selected and
to select the menu functions in the submenus
4 Button to call the OSD menu in the converter
mode; when the button
same time, the unit will be reset to the factory set-
tings
in the OSD menu: to select the submenus and to
change the settings
1.2 Rear panel (fig. 2)
5 Phono jack COMPOSITE to connect a video
source (e. g. camera, video recorder, DVD player,
games console) with composite signal
6 Mini DIN jack S-VIDEO to connect a video source
(e. g. camera, video recorder, DVD player, games
console) with S-video signal
7 D-SUB jack VGA to connect a PC
8 D-SUB jack MONITOR to connect the monitor
9 Power supply jack 5 V /500 mA to connect the
plug-in power supply unit supplied
(4) is pressed at the
(2) is pressed at the

2 Safety Notes

The units (converter and power supply unit) corre-
spond to all required directives of the EU and are
therefore marked with
WARNING The power supply unit is supplied with
hazardous mains voltage. Leave servic-
ing to skilled personnel only. Inexpert
handling may cause an electric shock
hazard.
Please observe the following items in any case:
The converter and the power supply unit are suitable
for indoor use only. Protect the units against dripping
water and splash water, high air humidity, and heat
(admissible ambient temperature range 0 – 40 °C).
Do not operate the converter and immediately dis-
connect the power supply unit from the socket
1. in case of visible damage to the converter or to the
power supply unit,
2. if a defect might have occurred after the unit was
dropped or suffered a similar accident,
3. if malfunctions occur.
In any case the converter and the power supply unit
must be repaired by skilled personnel.
For cleaning only use a dry, soft cloth; never use
water or chemicals.
No guarantee claims for the units and no liability for
any resulting personal damage or material damage
will be accepted if the converter or the power supply
unit is used for other purposes than originally in-
tended, if it is not correctly connected, operated, or
not repaired in an expert way.
If the units are to be put out of operation de-
finitively, take them to a local recycling plant
for a disposal which is not harmful to the envi-
ronment.
3 Applications
This converter allows to convert signals of any video
sources, e. g. cameras, video multiplexers, video
recorders, DVD players, or games consoles into a
VGA signal and to display them on a PC monitor. The
video signal may be available in the composite format
or in the S-video format. Via the OSD menu, it is pos-
sible to switch between the two video inputs.
The converter also has a VGA feed-through input to
connect a PC so that it is possible to switch between
the converted video signals and the VGA signal of the
PC. A VGA cable is supplied to connect the PC to the
converter.
The OSD menu allows to adjust picture properties
such as brightness, contrast, colour, sharpness, resolu-
tion, picture frequency, and the type of menu insertion.
.
GB
7