Functional Description; Overview; Technical Specifi Cations; Notes On Safety - ULTIMATE SPEED UPM 120 B1 Originalbetriebsanleitung

Functional description

The device is designed for waxing and
polishing or dewaxing of vehicle varnish.
Rotating the polishing disc helps achie-
ve a consistent mode of operation. The
polishing bonnets can be exchange for
different applications and detachable for
cleaning.

Overview

1 Handle
2 ON / OFF switch
3 Polishing disc
4 2 Synthetic fur covers
5 2 Towelling covers
6 Mains cable
Technical specifi cations
Electric polisher ........... UPM 120 B1
Rated input voltage (U) 230-240 V~, 50 Hz
Power input (P) ............................ 120 W
Idling speed (n ) .....................3500 min
0
Safety class .....................................
Protection category ..........................IPX0
Weight .................................. ca. 2.3 kg
Sound pressure
level (L ) ............... 61.7 dB(A); K
pA
Sound power level (L
measured .......... 72.7 dB(A); K
guaranteed ........................... 76 dB(A)
Vibration (a ) ....17.543 m/s
h
Levels of noise and vibration were determi-
ned according to the norms and regulati-
ons in the declaration of conformity.
- The specifi ed total vibration values and
the stated noise emission values have
been measured according to a standar-
dised test method and can be used to
compare one power tool with another.
= 3 dB
pA
)
WA
= 3 dB
WA
; K= 1.5 m/s
2
- The specifi ed total vibration values and
the stated specifi ed noise emission va-
lues can also be used for a provisional
assessment of the load.
Warning: The vibration and noise
emissions may deviate from the spe-
cifi ed values during actual use of the
power tool, depending on the type
and manner in which the power tool
is used – and in particular which
type of workpiece is processed.
Try to keep the exposure to vibrations
as low as possible. Examples of mea-
sures to reduce vibration exposure are
the wearing of gloves when using the
tool and limiting the working hours. For
this purpose all parts of the operating
cycle have to be considered (for ex-
ample, times when the electric tool is
switched off and times when it is swit-
ched on but running without any load).

Notes on safety

-1
II Caution! When using power tools,
observe the following basic safety
measures for the prevention of electric
shocks and the risk of injury and fi re.
Please read all these instructions
before using this electric tool and
please keep the safety instructions.

Symbols and icons

2
Symbols on the device:
Warning!
Read the manual!
Wear eye protection
Wear breathing protection
GB IE NI
5