Davey EcoSalt 2 DES2-25EL Installations- Und Betriebsanweisungen Seite 27

3. TDS LEVELS
WARNING: Some people recommend that you put salt directly in the skimmer box.
This is a poor practice as it allows very high concentrations of salt to be passed
through your filtration and other pool equipment.
Salt is the essential element by which your EcoSalt2 operates with. Insufficient Salt will damage your cell.
RECOMMENDED SALT LEVEL RANGE
EcoSalt2 model
DES2-15EL, DES2-25EL
DES2-15E, DES2-25E, DES2-35E
WARNING: Do not add Hydrogen Peroxide to pool water or through swimming
pool hydraulic, or sanitiser system. Use of Hydrogen Peroxide will void warranty
on Davey products.
Salt is NOT used up in the chlorination process, or by evaporation. It is only lost through dilution caused
from: backwashing, splash-out, overflow, leakage from the pool, or plumbing. Heavy rain can dilute the salt
levels in your pool therefore, salt levels should be checked during these events.
Low salt levels will destroy the coating on the cell plates and will void all Warranty.
The EcoSalt2 has a built-in warning indicator to minimise damage resulting from insufficient salt levels however,
the ultimate responsibility is on the owner to ensure adequate salt levels are maintained all year round.
4. RUNNING TIMES
These instructions cover EcoSalt2 for residential use only.
If you run your Sanitiser on maximum output for, 24 hours a day, or for longer periods, the cell life will be
greatly reduced. It is important that the correct model EcoSalt2 has been installed on your pool. Many
models are available from Davey to cope with small courtyard pools up to commercial size pools. (Consult
your local EcoSalt2 Dealer for more information).
Note: The EcoSalt2 warranty does not apply to commercial or semi-commercial applications, i.e. where the
pool chlorine demand is far in excess of a typical residential pool.
Operating salt level
1,500 – 6,000ppm
3,000 – 6,000ppm
27
Add salt alarm
~ 1,500ppm
~ 3,000ppm