Conformity Notes - Powerfix Profi PLS 10 A2 Bedienungsanleitung Und Sicherheitshinweise

1. Loosen the 4 Philips screws (arrows) on
the black cover on the battery LED emitter
(A) back panel.
2. Tilt the black cover over.
3. Disconnect the plug of the battery cable
(arrow) and remove the battery.
Dispose of the battery and the LED emitter separately.

12. Conformity notes

This battery LED emitter has been approved for compliance with the basic
and other relevant requirements of the EMC Directive 2014/30/EU, the
Low-voltage Directive 2014/35/EU and the ERP Directive 2009/125/EC.
The complete EU Declaration of Conformity is available on request at:
ce@targa.de
Respect the environment. Old batteries must not be disposed of with
domestic waste. They must be handed in at a collection point for waste
batteries. Please note that batteries must be disposed of fully discharged
at appropriate collection points for old batteries. If disposing of batteries
that are not fully discharged, take precautions to prevent short circuits. To
prevent any short circuits, cover the battery cable plug with insulating
tape.
Powerfix PLS 10 A2
English - 31