Fig.7 Assembly Of Glass Elements And Aluminium Profi Les; Fig.8 Control Panel - Igloo KASIA GRZ Bedienungsanleitung

• The fi rst cleaning of the device should be provide right after unpacking, and before turning it on. The unit should
be cleaned with water at a temperature not exceeding 40°C with a neutral detergent. For washing and cleaning
the equipment it is prohibited to use products containing chlorine and sodium varieties, which destroy the protecti-
ve layer and components of the device! Any residue of adhesives or silicone on metal elements should be remo-
ved only with extraction naphtha (not applicable to items made of plastic !). Do not use other organic solvents.
When cleaning the unit is prohibited to use water jet. The unit should be cleaned with a wet rag.
• If the user shall obtain a device partially disassembled to secure it during transportation, perform the following operations:
I. Mount glass sides Fig.7/8 (p.11)
II. Mount the aluminium lamp (together with lighting) on glass sides Fig.7/2 (p.11)
III. Mount the front glass, basing it on the lamp and glass sides Fig.7/1 (p.11)
IV. Mount aluminium profi les under the glass shelf (optional) Fig.7/6 (p.11)
V. Mount the glass shelf Fig.7/4 (p.11)
VI. Mount the casing of lamp conduit Fig.7/9 (p.11)
Move the casing of lamp conduit to the back of the glass side, in order to hide the conduit coming out of the lamp in the
casing and to place it on the internal part of the glass side!
• Check whether the water outfl ow ball valve is closed Fig.1/11 (p.9)
• Fill bain-marie tank with proper amount of clean water Fig.9 /2 (p.12)
• Place heater screens in bain-marie tank Fig.9/1 (p.12)
• Place cross-bars under GN containers on the bain-marie tank Fig.3 (p.9)
• Place empty GN containers in the chamber according to Fig.4 (p.10)
• Place the plug of the connecting cable directly in plug-in socket (it is forbidden to connect the device by means
of extension cords or dividers!)
• Turn on the main switch Fig.8/1 (p.11), which activates the electric heaters of bain-marie tank
• Set the desired temperature on thermostat control panel Fig.8/3 (p.11)
• After obtaining the desired water temperature, put hot grocery products in GN containers
• Turn on the lighting switch Fig.8/2 (p.11)
8 1 2
7
Fig.7 Assembly of glass elements and aluminium profi les
1 – Bent front glass, lifted
2 – Aluminium lamp
3 – Aluminium lamp hole plug
4 – Glass shelf
5 – Upper aluminium profi le (lifted guide) of the glass
6 – Aluminium profi le (pipes) under the glass shelf
1 2 5 3
www.igloo.pl
3 4
4

Fig.8 Control panel

1 – Main switch – turn on/off bain-marie heaters
2 – Light switch
3 – Temperature regulator knob
4 – Green diode – signals low water level
5 – Red diode – signals very low water level
8
9
10
5
6
7 – Glass shelf fi xing element
8 – Glass side
9 – Lamp conduit protection
10 – Working top
11 – Night screen guide
User manual Kasia GRZ
en
11
11