Changing The Diaphragm - Zodiac G2 Montageanleitung

Schema J
2
Schema K
Schema L
7
Trouble-shooting
1

CHANGING THE DIAPHRAGM

STAGE 1 : REMOVING THE DIAPHRAGM
1. Hold the main body of the G2 and disconnect the cassette from
The body. Remove the cassette from the body of the G2
2. Whilst holding the outer extension pipe with one hand, unscrew
the cassette chamber completely
3. Take hold of the diaphragm and remove it from its cassette
4. Withdraw the diaphragm from the inner extension pipe without
removing the retaining ring on the diaphragm
3
4
STAGE 2 : ADJUSTING THE SPECIAL G2 DIAPHRAGM
If the opening of the diaphragm's cavity is too large (over 4 mm),
but the diaphragm is not damaged or torn, you can solve the problem
by leaving one ridge of the diaphragm exposed from the cassette
chamber. This may eradicate any performance-related problems -
cleaner stopping, coverage problems
STAGE 3 : RE-FITTING THE DIAPHRAGM
1. Fit the diaphragm to the inner extension pipe.
5
If it is a new diaphragm, do not forget to put the retaining ring in
place
2. Slide the upper part of the inner extension pipe (end opposite
6
the diaphragm) into the lower part of the cassette.
The diaphragm must fit perfectly into the lower part of the cassette
3. Screw the cassette chamber to the cleaner's outer extension pipe.
Do not over tighten.
4. Reinsert the cassette into the body and tighten the outer extension
pipe/cassette unit, until it has clicked into place
.
5
(Schema J)
.
2
.
4
(Schema K) .
(Schema L)
.
7
1 .
3 .
6 .