Exterior Ceiling Mounting - Axis 231D Installationsanleitung

Installing the AXIS 231D/232D
6

Exterior Ceiling Mounting

Fixing
screw
Follow these instructions to mount the dome camera:
1. Using the supplied drill template, drill three holes in the hard ceiling and secure the
bracket to the ceiling with three screws.
2. Connect the connection module cable to the connection module.
3. Connect the Ethernet cable and connection module to the AXIS
231D/232D.
4. Connect the power cable and check that the power and network
LEDs light up (green).
5. Mount the dome body to the bracket and rotate it clockwise.
Make sure the screw hole on the side of dome is aligned with the
bracket. Tighten the fixing screw to secure the dome.
6. Attach and secure the Decoration ring to the bracket.
7. The hardware installation is now complete, proceed to Installing on a Network, on
page 8 to install the AXIS 231D/232D on your network.
Network
connector
Connection
module
connector
Network LED
Power LED
Decoration
ring